Mrtg For Windows 7

Choose the location to unzip MRTG and then choose Extract. After the extraction process completes, close WinZip. (This set up uses F:.) Navigate to the location you. Choose the location to unzip MRTG and then choose Extract. After the extraction process completes, close WinZip. (This set up uses F:.) Navigate to the location you extracted MRTG to and notice the odd name on the folder. Right Click on the folder and select Rename. Change the name to mrtg. Create a new folder called on the same drive called mrtghtml. Hello, PRTG Network Monitor 7 does support Windows 7 64bit. The PRTG Traffic Grapher 6 may run under Windows 7 (64bit), but this is not officially supported nor tested.

I suggest you do the following from the machine that will be running MRTG, which, in this case, is also a web server. All examples are for doing things to a LOCAL machine. First Unzip MRTG to C: mrtg-2.17.4 on the Windows machine of your choice. Next Install Perl on the same Windows machine. You might want to make sure that the Perl binary directory is listed in your system path. C: Perl bin;%SystemRoot% system32;%SystemRoot%. You can manually check this by going to [Control Panel]->[System]->[Environment] To see if everything is installed properly you can open a Command Shell and go into c: mrtg-2.17.4 bin.

Sudden Strike Forever Maps on this page. Type: perl mrtg This should give you a friendly error message complaining about the missing MRTG configuration file. Now, you have successfully installed MRTG and Perl.

Now it is time to create a configuration for MRTG. But before we begin you need to know a few things. Take an opportunity to gather the following information: • The IP address or hostname and the SNMP port number, (if non standard), of the device you want to monitor. • If you want to monitor something other than bytes in and out, you must also know the SNMPOID of what you want to monitor.

• Finally you need to know the read-only SNMP community string for your device. If you don't know it, try public, that is the default.

For the rest of this document we will be using device 10.10.10.1 ( a CISCO Catalyst 5000) with Community string public. We are interested in monitoring traffic, and the CPU load.

The first thing we do in setting up MRTG is making a default config file. Get to a cmd prompt and change to the c: mrtg-2.17.4 bin directory. Type the following command: perl cfgmaker public@10.10.10.1 --global 'WorkDir: c: www mrtg' --output mrtg.cfg This creates an initial MRTG config file for you. Note that in this file all interfaces of your router will be stored by number.